鋁合金免烘烤油墨

鋁合金耐酒精油墨

1、油墨特性：低氣味，高光澤，色澤鮮艷，遮蓋力強，耐酒精，耐汽油，抗腐蝕。

2、適用材料：主要應用于各種五金、鋁合金、不銹鋼、氧化鋁、白鐵電鍍、PP材料。

3、技術參數：

a.粘度：8000—12000CPS；

b.細度：5UM↓ 、光澤：60°↑ ；

c.干燥條件：65℃—70℃，25min 自干24小時

d.鉛筆硬度：2H↑ ；

e.耐鹽務性：24H；

f.耐酒精：99％乙醇500g力來回30次；

g.耐磨：500g力來回超過30次；

h.過網性：77T—145T網紗〔金、銀粉調配顏色除外〕

4、稀釋劑的選擇：稀釋劑：S—783：便用前添加13％—15％的DB—01固化劑。

5、注意事項：

a.使用前將油墨與固化劑攪拌均勻，用后4個小時后須更換新的油墨,以便出現干網,和固化劑凝固!

b.根據需要可添加15％—20％的稀釋劑進行稀釋；

c.施工件在施工前清除表面油漬及污物；

d.需多色套印時應等前面的顏色表干后進行套色；

e.在作測試時應先讓墨層完全干燥；

d.不得將油墨與其它油墨混合及配色，添加固化劑后，效果會大大的改善，若加固化劑后請將油墨在4小時用完。

6、應急處理措施：

a.如浸濺到眼部立即清水清洗，嚴重者就醫。

b.滅火急救措施：用干粉，泡沫滅火器或沙子滅火。

※備注：由于材料及使用中的變數，可能是結果會有變化，以上數據僅供參考，使用前請自行測試。

1, ink characteristics: low odor, high gloss, bright color, hiding power, alcohol, gasoline, corrosion resistance.

2, applicable materials: mainly used in all kinds of hardware, Aluminum Alloy, stainless steel, aluminum, tin plating, PP material.

3, technical parameters:

A. viscosity: 8000 - 12000CPS;

B.: 5UM:: gloss, fineness of 60 degrees up;

C. drying conditions: 65 DEG C - 70 DEG C, 25min dry for 24 hours

D. pencil hardness: 2H up;

Salt resistance: 24H e.;

F. alcohol resistance: 99% ethanol 500g force back and forth 30 times;

G. wear: 500g force back and forth more than 30 times;

H. network: 77T - 145T Jacobs, except gold and silver powder colors.

4, diluent choice: diluent: S - 783: before use, add 13% - 15% of DB - 01 curing agent.

5, matters needing attention:

A. use before the ink and curing agent mixing evenly, use 4 hours later, must replace the new ink, in order to appear dry nets, and curing agent solidification!

B. may add 15% - 20% diluent to dilute as needed;

C. construction parts to remove surface grease and dirt before construction;

D. multicolor, should wait for the color table in front of dry color;

E. should allow the ink layer completely dry when testing;

D. shall not ink and other ink mixing and color matching, add curing agent, the effect will be greatly improved, if add curing agent, please ink in 4 hours run out.

6, emergency treatment measures:

A. if splashed to the eye, immediately clean water, serious medical treatment.

B. fire emergency measures: use dry powder, foam extinguisher or sand to extinguish fire.

Please note: due to the material and the use of variables that may be the result of a change, the above data for reference only, please test before use.